Product Code: PRO-SW4000

GTO/PRO Swing Gate Operator


PRO4000 and PRO4200
for Double Gates Shown

Low Voltage Swing Gate Operator designed for tubular steel, vinyl, wood, or ornamental gates for residential, farm and commercial use. The PRO4000 is for single swing gates. Add the slave unit PRO4200 for a double swing gate (below).

  • 12 volt system, no electrician needed for installation
  • Gate will work during electrical power outage
  • Quick and easy installation, with user friendly instructions
  • "The Shadow" is designed to blend in with your gate
  • Solar Panel Charger available for remote locations
  • Will operate a gate up to 20' long and weighing up to 1000 lbs. each leaf
  • Can operate 100 to 150 gate cycles during peak hours of operation, depending on gate size and weight (see cycle chart link below)
  • Control box can be mounted in protected area away from receiver (may require longer cables)
  • Control box measures 18-1/2" high x 14-1/4" wide x 7-1/2" deep
  • Receiver unit with antenna and 10' cable can be placed in best location for reception of signal
  • Can be operated by remote transmitter, digital keypad, push button or combination
  • Full systems capable "add on ready" heavy-duty control board includes adjustable obstruction sensing, gate sequencing and auto close settings (0-120 seconds)
  • High cycle capability with true soft start and stop operation
  • Full access ready package includes battery, radio receiver, entry transmitter, AC transformer, and all necessary mounting hardware for a standard installation
  • Can operate as 'push to open' or 'pull to open' (specify when ordering - extra hardware required for push to open)
  • UL rated for Class I, II, III & IV. System certified to be in compliance with UL 325, 4th edition
  • Two-year limited warranty applies to replacing parts from GTO, Inc.
  • 30 day satisfaction guarantee from Hoover Fence

Technical Specifications:

Drive
  • Powered by resilient 12 volt motor, 64:1 planetary gear drive system.
  • Temperature rating of motor: -30ºF (-34ºC) to +160ºF (+71ºC)
  • Opening time is 18-20 seconds
  • Range of arm stroke is up to 22" (56 cm), with arm fully retracted is 46.25" (118 cm), mounting point to mounting point
 
Power
  • The PRO-SW4000 system is powered by a 12 volt DC/7.0 amp hour, sealed, rechargeable battery
  • Optional second battery fits in control box, used for solar applications or high traffic applications, if needed
  • Battery charge maintained by a 120V AC/60 Htz input, transformer rectified to 14 V DC through the GTO Control Board.  NOTE: Transformer should never be connected directly to any battery
  • Optional GTO Solar Panel Charger: float voltage 14.5 V DC output from a 19-3/8" (49.21 cm) x 15-1/4" (38.74 cm) silicon alloy panel. Generates minimum of 10 watts at 600 mA. A gated diode on the control board prevents battery discharge
 
Controls
  • The GTO control board can be programmed for pull-to-open or push-to-open
  • Adjustable auto close, obstruction sensitivity and dual gate sequencing
  • Slow Start/Stop for added cycles and system life
  • Auto-memorization of digital transmitter code
  • Charging regulated circuit on control board. "Sleep draw" is 40 mA; "active draw" is 2 to 9 amps
  • GTO remote-mounted RF receiver tuned at 318 MHz

Includes:

  • Operator arm
  • AC transformer
  • 12 volt battery
  • Control box/control board
  • Receiver with 10 ft. cable
  • Entry transmitter
  • 6 ft. power cable
  • Mounting hardware
  • Installation/safety manual
  • Caution signs.
  • Warning Beeper
  • Adjustable obstacle-reversing safety feature

Product Code: PRO-SW4200

GTO Slave Operator for PRO4000 only

Add this unit to the PRO4000 above and your system will operate a double swing gate up to 40' wide (20' each leaf). Burying the power cable directly across the driveway is fine. It can be snaked through conduit also. Cable is 1/4 inch diameter with a 1 inch plug on one end only.

Includes:

  • Operator arm
  • 50' power cable - wires into the control box of the PRO4000
  • Mounting hardware
  • NOTE: This operator will not work as a stand-alone unit. It is a slave unit without a control box and is meant to hook up to the PRO4000 control box for use with a double gate.

 

GTO PRO-SW4000 & PRO-SW4200

Home
Up
Our Products
Gate Specials 1
Quote Request
Installation Help
Manuals
Feedback
What is Powdercoat
Shipping Policy
Privacy Policy
Testimonials
Contact Us
CAREERS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Home Up Our Products Gate Specials 1 Quote Request Installation Help Manuals Feedback What is Powdercoat Shipping Policy Privacy Policy Testimonials Contact Us CAREERS